Peak Male Physique
Wato Pump Bundle - Digital Pump & Cylinder
Wato Pump Bundle - Digital Pump & Cylinder
In stock
The recommended size is selected below when available. Keep the selected length if that diameter is offered. The 9-inch length is preferred when in stock. A cylinder wider than needed can impair fit and seal.
Couldn't load pickup availability
FREE SHIPPING over $20 to US, CAN, UK, EU
Worldwide Shipping
Free Returns
Discreet Packaging
Wato Waterproof Automatic Pump Kit
The flexibility of water or air pumping, with the control of a fitted cylinder and rechargeable automatic pump. This bundle combines the IPX8-rated Wato Water Smart Pump with a clear acrylic cylinder in the size you choose. No separate cylinder purchase needed.
You get automatic pressure hold, nine Smart Modes, adjustable Manual Mode and USB-C charging. Already own a compatible cylinder? Choose the pump-only version instead.

Exactly what's in the bundle
- Wato Water Smart automatic pump
- One fitted clear acrylic cylinder in your selected size
- Compatible direct-connection setup for the included cylinder
A standard hose setup is also supported if you prefer that configuration. Choose your cylinder size above before adding the kit to your cart.
One kit, two ways to pump
Water or air, your choice
IPX8 water resistance supports wet-environment pumping. Use the Wato directly attached to a compatible cylinder or through a standard hose setup.
Automatic pressure control
See your vacuum level, use auto-hold to maintain pressure and follow a built-in timer instead of manually pumping throughout your session.
Nine smart cycling modes
Select a preset pulsation pattern at a fixed pressure and time, with automatic cycling and release.
More control in Manual Mode
Choose your own vacuum level and stop pumping when you reach it. Wato supports up to 45 kPa vacuum magnitude, not a recommended operating target.
Also included: USB-C charging and an integrated session timer. Typical charge time is approximately two hours, with up to two hours of use per charge depending on conditions.


Choose your fitted cylinder
Don't guess on sizing. Measure your erect girth at its widest point, including your base if it is widest. Then use the PMP Size Calculator to select a cylinder that gives you a comfortable seal and room for expansion.
| Cylinder | Maximum recommended erect girth |
|---|---|
| 9 × 1.75 in | Up to 5.5 in |
| 9 × 2.0 in | Up to 6.25 in |
| 9 × 2.125 in | Up to 6.66 in |
| 9 × 2.25 in | Up to 7.0 in |
As a starting guideline, allow roughly 10–15% room for expansion, but avoid an excessively wide tube. The 9 × 2.25-inch variant is currently the stocked 2.25-inch option; the 12 × 2.25-inch and 9 × 2.5-inch variants are listed at zero stock. Check the selector for current availability.
How to use the Wato controls
Manual Mode is the place to start. Its adjustable vacuum gives you control over the pressure. Smart Mode uses fixed presets, which cannot be customized.
- Power: Hold the power button for three seconds to turn the unit on or off. In Manual Mode, press once to begin pumping and again to stop when you reach your intended pressure.
- Release: Press the air-release button once to reduce pressure, or press and hold to release it fully.
- Smart: Press the Smart button to enter Smart Mode. Press it again to cycle through the nine preset modes.
- Return to manual control: While in Smart Mode, pressing Power or Air Release switches back to Manual Mode.
Know this before using Smart Mode: Presets run at −20, −30 or −40 kPa for 20-minute programmed cycles. Their pressures and timing are fixed. For lower or individually adjusted pressures and shorter sessions, use Manual Mode. Higher-pressure presets are not appropriate beginner settings.
All nine Smart Mode presets
Three vacuum levels, each with three cycling patterns. Each preset is programmed for 20 minutes. You can stop or release pressure sooner.
| Mode | Vacuum | Pattern |
|---|---|---|
| 1 | −20 kPa | Pump to target; release to zero; repeat |
| 2 | −20 kPa | Pump; hold 1 minute; release to zero; repeat |
| 3 | −20 kPa | Variable-frequency pumping and releasing |
| 4 | −30 kPa | Pump to target; release to zero; repeat |
| 5 | −30 kPa | Pump; hold 1 minute; release to zero; repeat |
| 6 | −30 kPa | Variable-frequency pumping and releasing |
| 7 | −40 kPa | Pump to target; release to zero; repeat |
| 8 | −40 kPa | Pump; hold 1 minute; release to zero; repeat |
| 9 | −40 kPa | Variable-frequency pumping and releasing |
Why people use vacuum pumping
Vacuum pumping is commonly used for erection-quality routines and temporary fullness, as well as by customers following longer-term size-focused routines. These are the benefits customers most often seek:




Temporary fullness is the most predictable immediate effect. Erection response and sensation vary, and permanent enlargement is not guaranteed.
First session and water-use guidance
Start with gentle pressure and a short session. Do not use the maximum vacuum range as a target. Stop and release pressure if you notice pain, numbness, pronounced discoloration or bruising. If you have a relevant medical condition, seek professional advice before using vacuum equipment.
Wet use: Wato carries an IPX8 water-resistance rating and is designed for water or air pumping. Follow the product's water-use and immersion instructions, keep the USB-C port clean and dry before charging, and never charge it in a wet environment. An IPX8 rating does not mean there are no limits on depth, temperature or exposure.
For help with programming, read Ways to Pump or use PMP's pressure conversion calculator.
Quick answers before ordering
Is a cylinder included? Yes. This is the pump-and-cylinder bundle; select the cylinder size you want from the variants above. The Wato pump is also available separately.
Do I need an additional hose? The included configuration allows direct connection to your selected cylinder. Wato also supports a standard hose arrangement if you prefer one; check the accessory configuration when ordering.
Can I use water or air? Yes. Wato is IPX8 water-resistant and supports both, with appropriate setup and care.
Can I customize a Smart Mode? No. The nine Smart Modes use fixed pressure and time presets. Use Manual Mode for custom pressure.
What if I cannot maintain a seal? Check the selected cylinder fit, connection and positioning before increasing vacuum. The right size is more important than choosing the largest diameter.
Safety & Disclaimer
Safety & Disclaimer
Adults 18+ only. Peak Male Physique is not liable for any outcomes resulting from product use. The customer assumes full responsibility. Any suggestions are optional and not a substitute for personal responsibility or medical advice. Our products are not intended to diagnose, treat, cure, or prevent any medical condition.
Share







Shipping
✓ Free Shipping & No Duties to US, CAN, UK, EU
✓ Worldwide Shipping
✓ Discreet Packaging
✓ Next Business Day Shipping
Returns
✓ 14-Day Returns
✓ Free Return Shipping
✓ No Restocking Fees
✓ Easy Exchanges